Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the neutral
lock position. Lift the seat forward.
The following components can be accessed by raising the seat:
•
Service decal
•
Fuses
•
Battery and cables
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to gain access to the
top of the mower deck
(Figure
2
Figure 41
1. Bottom bolt
41).
1
g027673
2. Curtain
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 general purpose lithium base grease
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
a rag. Make sure to scrape any paint off of the front
of the fitting(s).
1. Front caster tire
4. Connect a grease gun to each fitting
Figure
42). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
32
(Figure 42
and
Figure
1
G009949
Figure 42
(Figure 40
40) with
and