Automatic Stability Control Asc; Asc - BMW R1200GS Rider's Manual

4
64
Press and hold down button 1
until the ABS warning light
changes status.
z
Initially, the ASC symbol
changes status. Press and hold
down button 1 until the ABS
warning light responds. Under
these circumstances, there is
no change in the ASC setting.
ABS warning light flashes.
Release button 1 within two
seconds.
ABS warning light contin-
ues to flash.
The ABS function is deactiv-
ated, but the integral function
remains active.
Activating the ABS
function
Press and hold down button 1
until the ABS warning light
changes status.
ABS warning light goes out;
if self-diagnosis has not
completed it starts flashing.
Release button 1 within two
seconds.
ABS warning light remains
off or continues to flash.
The ABS function is activated.
You also have the option of
switching the ignition off and
then on again.
An ABS fault has occurred
if the ABS warning light
shows when the motorcycle ac-
celerates to a speed in excess
of 5 km/h after the ignition was
switched off and then on again.
See the section entitled
"Engineering details" for
more information on the brake
system with BMW Motorrad In-
tegral ABS.
Automatic Stability
Control ASC
Deactivating the ASC
function
Switching on ignition ( 44).