BMW R1200GS Rider's Manual page 69

(Enduro and Enduro Pro) dur-
ing on-road riding can result in
unstable riding conditions when
braking with ABS intervention or
accelerating with ASC interven-
tion. This could cause a fall.
Activate off-road mode (Enduro
and Enduro Pro) only for off-road
riding.
Press button 1 as often as ne-
cessary until the required riding
mode is indicated next to the
selection arrow.
Enduro PRO
When the
mode is selected: note that
ABS control for the rear wheel
is restricted (see the section en-
titled "Engineering details").
The following ride modes can be
selected:
RAIN
: for riding on a rain-wet
road surface.
ROAD
: for riding on a dry road
surface.
OE
with Pro riding modes
The following riding modes are
additionally available for selec-
tion:
DYNA
: for dynamic riding on a
dry road surface.
Enduro
: for off-roading.
Enduro PRO
: for sporty off-
road riding (with fitted coding
plug only).
With the motorcycle at a stand-
still, the selected mode is ac-
tivated after approximately two
seconds.
The newly selected riding
mode is activated as you
ride only when the following
preconditions are satisfied:
Throttle twistgrip in idle posi-
tion
Clutch pulled
Following activation of the new
riding mode the clock is dis-
played again.
The riding mode set, with the
corresponding adaptations of
engine characteristics, ABS,
ASC and Dynamic ESA, is re-
tained even after the ignition
has been switched off.
Deactivate the RDC for
off-roading
with Pro riding modes
You can deactivate RDC warn-
ings for the Enduro and Enduro
Pro riding modes when you want
to lower the tyre pressures for
off-roading.
Switching on ignition (
4
67
OE
z
44).