Troubleshooting Components; Monitoring The Srx240 Services Gateway Components Using Leds; Table 41: Component Leds On The Srx240 Services Gateway; Chapter 17 Troubleshooting Components - Juniper SRX240 Hardware Manual

CHAPTER 17

Troubleshooting Components

Monitoring the SRX240 Services Gateway Components Using LEDs

Copyright © 2015, Juniper Networks, Inc.
Monitoring the SRX240 Services Gateway Components Using LEDs on page 107
Monitoring the SRX240 Services Gateway Chassis Using the CLI on page 111
Monitoring the SRX240 Services Gateway Using Chassis Alarm Conditions on page 113
Monitoring the SRX240 Services Gateway Power System on page 115
Loading the Rescue Configuration on the SRX240 Services Gateway on page 117
Changing the Reset Config Button Behavior on the SRX240 Services
Gateway on page 118
Juniper Networks Technical Assistance Center on page 118
The LEDs on the services gateway display the status of various components.
Table 41 on page 107 describes the LEDs.

Table 41: Component LEDs on the SRX240 Services Gateway

LED State
Status LED Green
Yellow
Red
Meaning
The services gateway is
functioning normally.
The services gateway is
starting up.
The RESET CONFIG
button is pressed.
An error is detected in the
services gateway.
Possible Causes and
Corrective Actions
Normal condition. No action
is required.
Normal condition. No action
is required.
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See "Juniper Networks
Technical Assistance
Center" on page 118.
107