Table of Contents
Advertisement
Basic shooting operations
Preparing for recording
1
Set the camera's power switch to OFF.
(Page 26)
•
Check that the mode lamp is off.
2
Slide the card cover release lever, and open
the SD Memory Card cover.
Slide to the
left to open.
3
Fully insert an SD Memory Card into the
card slot.
•
Insert the card in the direction shown until it
clicks into place.
4
Close the SD Memory Card cover.
•
Ensure that the cover firmly clicks into place.
AG-HMC41E(VQT2H31(E))̲E.indb 33
AG-HMC41E(VQT2H31(E))̲E.indb 33
ACCESS lamp
· Flashes during SD
Memory Card access
(recognition, recording,
playback, deletion, etc.).
For details, see "SD
Memory Card ACCESS
lamp".
•
Do not perform any of the following operations
while the SD Memory Card ACCESS lamp is
flashing.
Performing these operations may damage the
SD Memory Card or its contents, or cause the
camera to fail to operate correctly.
·
Opening the card door and removing the SD
Memory Card
·
Switching off the power
·
Removing the battery
·
Connecting or disconnecting the USB
connection cable
·
Shaking or striking the camera
•
Always format SD Memory Cards that have
been used in other devices when first using
them with this camera. (Page 35)
•
If "CHECK CARD" is displayed on the
viewfinder or the LCD monitor, please remove
the SD Memory Card and insert it again.
SD Memory Card ACCESS lamp
This lamp lights or flashes during memory card
access.
Lit: Card inserted, read/write possible
Flashing (fast): Recognizing
Flashing (slow): Accessing (during recording/
playback/reading)
Off: Card not inserted, unformatted card inserted
SD Memory Card access lamp
33
2009/07/11 18:40:30
2009/07/11 18:40:30
Advertisement
Table of Contents
