Replacing The Armrest Height Adjustment Mechanism - Permobil Corpus 3G Service Manual

Repairs

Replacing the armrest height adjustment mechanism

Removal
1. Remove the backrest plates. For a detailed
description, see 18.
2. Loosen the two screws holding the plastic
cover to the back of the backrest. Twist the
plastic cover downwards. See the illustration.
3. Remove the BUS contacts from the contact
block and divide the cabling for the ICS
switchbox at the contacts on the cabling.
4. Remove the four screws that hold the armrests
in place. See the illustration. Then carefully
move the armrests downwards or backwards.
5. Remove the joint for the backrest slide
function, which is held in place by one screw.
See the illustration.
Replacing the armrest height adjustment mechanism
For this task the following tools are necessary:
1 Allen key 3 mm
1 Allen key 5 mm
The plastic cover is fixed using two screws.
1. The contact on the ICS switchbox cabling is
above the contact block. 2. The BUS contacts are
mounted on the contact block.
The armrests are held in place by four screws.
The joint for the backrest slide function is held in
20
place by one screw