Replacing The Fixed Seat Mounting Plate - Permobil Corpus 3G Service Manual

Repairs
Replacing the fixed seat mounting
plate
Removal
1. Switch off the main power switch on the control
panel.
2. Remove the seat cushion by lifting it straight
up. It is attached by means of Velcro on the
rear of the cushion.
3. Remove the seat plates, which are held in
place by two screws at the back edge and
two quick-mount clamps at the front. See the
illustration. First remove the screws, then use
your hand to carefully push the seat plate
from below to release the quick-mount clamps
at the front.
4. Remove the six screws that hold the seat in
place. Have someone help you by holding the
seat while you remove the screws, and then
helping you lift the seat and lay it next to the
chassis. Be careful with the seat cabling.
m WARNING!
The seat is heavy. This work should therefore
always be performed by two people. Be careful
with the cabling.

Replacing the fixed seat mounting plate

For this task the following tools are necessary:
1 Allen key 5 mm
1 Allen key 8 mm
The seat plates are held in place by two
screws at the back edge and two quick-mount
clamps at the front.
The seat is held in place by six screws.
32