Permobil Corpus 3G Service Manual page 22

Repairs
5. Remount the backrest profile by fitting the
bracket into the profile groove on the left and
right sides. Slide the profile downwards until
the stop on the bracket is touching the end
of the backrest profile on both the left side
and the right. Secure the backrest profile by
tightening the two screws on the left and right.
See the illustration. Tighten the screws using
a torque wrench.
Tightening torque 9.8 Nm.
6. Mount the armrests using the four screws
screws. See the illustration. Tighten the
screws using a torque wrench.
Tightening torque 9.8 Nm.
7. Mount the joint for the backrest slide function
using the screw supplied. See the illustration.
Tighten the screw using a torque wrench.
Tightening torque 9.8 Nm.
8. Mount the BUS contacts on the contact
block and mount the cabling for the ICS
switchbox at the contact on the cabling. See
the illustration at bottom left.
9. Remount the plastic cover on the back of the
backrest using the two screws supplied. See the
illustration at bottom right.
10. Remount the backrest plates. For a detailed
description, see 19.
1. The contact on the ICS switchbox cabling is
above the contact block. 2. The BUS contacts are
mounted on the contact block.
Replacing the armrest height adjustment mechanism
The backrest profile is secured using two screws
The armrests are held in place by four screws.
The joint for the backrest slide function is held in
The plastic cover is attached using two screws
23
on the left and right
place by one screw