TP-Link TL-SL3428 User Manual page 216

As the prompt is displayed for a short time, you are suggested not to release the CTRL-B key
until you enter into bootUtil menu after powering on the switch.
3） After entering into bootUtil menu, please firstly configure the IP parameters of the switch.
The format is:
kheqphki"kr xxx.xxx.xxx.xxx ocum 255.255.255.0 icvgyc{ xxx.xxx.xxx.xxx.
For example: Configure the IP address as 172.31.70.22, mask as 255.255.255.0 and
gateway as172.31.70.1. The detailed command is shown as below. Enter the command
and press Gpvgt.
]VR/NKPM_<"kheqphki"kr"394053092044"ocum"4770477047702"icvgyc{"39405309203"
4） Configure the parameters of the FTP server which keeps the upgrade firmware. Later you
can download the firmware to the switch from the FTP server. The format of the command
is: hvr"jquv"xxx.xxx.xxx.xxx"wugt"xxxxx"ryf"xxxxx"hkng"xxxxxx.bin.
Here take the following parameters of the FTP server as an example. IP address is
172.31.70.146; the user name and password for login to the FTP server are both 123; the
name of the upgrade firmware is tl_sl3428_up.bin. The detailed command is shown as
below. Enter the command and press Gpvgt.
]VR/NKPM_<"hvr"jquv"3940530920368"wugt"345"ryf"345"hkng"vnaun564:awr0dkp
5） Enter the upgrade command and press Gpvgt to upgrade the firmware. After a while, the
prompt "You can only use the port 1 to upgrade" will display in the hyper terminal shown
as the following figure.
]VN/NKPM_<"writcfg"
[qw"ecp"qpn{"wug"vjg"rqtv"3"vq"writcfg0"
6） When the prompt "Are you sure to upgrade the firmware[Y/N]:" displays, please enter [ to
start upgrade or enter P to quit upgrade shown as the following figure. The # icon
indicates it is upgrading. After upgrading, the [TP-LINK] command will display.
Ctg"{qw"uwtg"vq"writcfg"vjg"hktoyctg][1P_<"{"
###############################################
###############################################
###############################################
###################################
]VR/NKPM_<"
7） Please enter start command to start the switch shown as the following figure. Enter the
user name and password (the default user name and password are both admin) to login to
the CLI command window and you can manage the switch via CLI command.
]VR/NKPM_<"uvctv"
Figure 15-6 bootUtil Menu
208