Lada Kalina User Manual page 47

when the ignition is on. Remember
that when the lighting system works
the main beam is not turned on for a
long time. To turn on the main beam
for a long time, you must first change
the ELS switch to position «Dipped
beam».
Warning
The moment of switching the
exterior lighting with the auto-
matic control system cannot meet
safety requirements. Therefore,
the use of this system does not
relieve the driver of responsibility
for observing safety require-
ments and traffic rules.
Dipped beam adjuster switch.
Before operating the vehicle with the
dipped beam check for correct posi-
tion of handle 3 of dipped beam
electrical adjuster depending on the
vehicle load state:
0 – driver or driver + front passen-
ger;
1 – driver + luggage in the lug-
gage compartment;
2 – driver + 4 passengers;
3 – driver + 4 passengers + lug-
gage in the luggage compartment.
If necessary, adjust dipped beam
by turning the handle to align the
handle mark with one of the marks
on the scale corresponding to the
vehicle load state.
When setting the
adjuster handle to position outside of
the mark-up of the scale, there is
possible asynchronous passing of
dipped beam of the left and right
headlight units, which is not a defect.
Warning
Correct adjustment of the
beam angle reduces dazzling of
drivers of oncoming traffic.
To avoid poor lighting of road-
way do not set the handle to end
position counterclockwise.
Rear fog light switch. To switch
on the fog lights, press switch button
2 with the dipped beam on. Re-
pressing of the button turns off the
fog lights.
Front fog light switch (in the
design variant). To switch on the
fog lights, press switch button 4 with
the tail lights on. Re-pressing of the
button turns off the fog lights.
Warning
When driving in conditions
requiring fog lights or fog lamps,
with the automatic control system
of exterior lighting on (exterior
light switch is in position
the design variant) the exterior
light switch must be changed to
electrical position
– in
or .
45