Body - Lada Kalina User Manual

Fog light
Remove the inoperative bulb from
the fog light (Fig. 68). Turn socket 1
counterclockwise and remove it from
the reflector, disconnect the terminal
block from the bulb. The installation
of the new bulb should be carried out
in reverse order. Work on installing a
halogen bulb should be carried out
with gloves to avoid leaving traces on
the bulb. This type of work is recom-
mended to perform at any certified
SSNEs using the lift.
To access to the fog light under
the front wheel arch, you must first
remove the wheel and partially
loosen dash board by removing six
screws. Fold the dash board, remove
the burned-out light bulb from the
fog light.
In the design variant dash
boards of the vehicle are equipped
with special hatches for access to
the fog lights. If such a hatch is avail-
able the bulb replacement procedure
will be as follows:
– maximally turn the front wheel
inside the arch to access to the hatch
cover;
– turn the hatch cover of the dash
board counterclockwise and remove
the cover;
Fig. 68. Fog light
– after removing the cover you will
receive access to the bulb through
the hatch in the dash board;
– turn the bulb counterclockwise
and pull it out;
– disconnect the terminal block
and replace the bulb.
The installation of the new bulb
should be carried out in reverse or-
der. It is recommended to remove the
front wheel in order to make the work
on bulb replacement easier.

BODY

Body is the basic and the most
costly component of the vehicle. It is
made of advanced materials and
protected against corrosion with
high-quality protective equipment.
The basis of corrosion protection
lifetime is laid by the manufacturer,
however, paints and other protective
and decorative coatings are subject
to normal wear and ageing. The
effectiveness of corrosion protection
and its lifetime depend on climatic
conditions, ecological environment,
conditions of use, storage, proper
care and timeliness of preventive
measures.
Do not apply high efforts to open
or close the doors and the bonnet
and control movements of them; oth-
erwise, it can result in injury and/or
rubbing of the doors and the body,
for which the manufacturer is not
responsible.
In order not to have paint coatings
on the body and outer optical sur-
faces on the fixtures of the vehicle
scratched, do not remove dust and
dirt with dry cleaning material. In
order to keep the vehicle it is neces-
sary to wash it until the dirt dries with
spray of small water pressure using a
127