Simrad RS10U Manual page 3

RF Emissions Notice:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. This device's antenna must be installed in accordance with provided instructions; and it must
be operated with minimum 96 cm spacing between the antennas and all person's body (excluding
extremities of hands, wrist and feet) during operation. Further, this transmitter must not be co-located
or operated in conjunction with any other antenna or transmitter.
IMPORTANT:
1. DSC functions will not operate on the RS10U or the RS10E until your MMSI has been entered.
Refer to section 4.2 for details.
2. The radio channels installed into the Simrad VHF radio may vary from country to country, depend-
ing upon the model, and government or national communications authority regulations.
3. Navico recommends that you check the radio operating licensing requirements of your country
before using the Simrad VHF radio. The operator is solely responsible for observing proper radio
installation and usage practices.
4. A DSC warning label is supplied with the RS10U. To comply with FCC regulations, this label must
be affixed in a location that is clearly visible from the operating controls of this radio. Make sure
that the chosen location is clean and dry before applying this label.
Simrad RS10 Operation and Installation Manual
2