Gps Simulator (Simulator); Reset To Factory Defaults (Reset) - Simrad RS10U Manual

2-5-7 GPS Alert Options (ALERT)
The GPS alert is usually set to ON (on) so that if the GPS navigation receiver is disconnected, the alarm
sounds.
GPS/DATA
LL DISPLY
COG/SOG
> GPS ALERT

2-6 GPS Simulator (SIMULATOR)

The GPS Simulator is set to OFF whenever the radio is turned ON or whenever real GPS data is available
through the COM port. However, if you want to test it, turn it on.
MENU SELECT
DSC SETUP
RADIO SETUP
> GPS SIM
It is not possible to send a DSC transmission when in Simulator mode.

2-7 Reset to Factory Defaults (RESET)

Use this to return every setting to the factory defaults except all MMSI settings and the entries in your
buddy list.
MENU SELECT
RADIO SETUP
GPS SIM
> RESET
1. Select RESET. The radio asks for confirmation.
2. Select YES to reset the radio and return to the menu.
The Call Logs will be cleared but the BUDDY LIST will be saved. The receiver and transmitter factory
settings are restored to default conditions.
GPS ALERT
> ON
OFF
1. Select GPS SIM, then select ON (on) or OFF (off ) as desired.
Whenever the GPS Simulator is turned ON (on), simulated Speed Over
Ground (SOG), Course Over Ground (COG), and LL position appear on the
screen. This data is updated automatically during the simulation.
RESET RADIO
ARE YOU SURE
> YES
NO
Simrad RS10 Operation and Installation Manual
1. Select GPS/DATA, then SETTING.
2. Select GPS ALERT.
3. Select ON (on) or OFF (off ) as desired.
17