Control Panel / Touch Panel Display - Panasonic Workio DP-C305 Operating Instructions Manual

Control Panel / Touch Panel Display

Touch Panel Display
Machine Condition LED
ATTENTION
To adjust the brightness of the Touch Panel Display, press and
hold down the Clear key, and press the 1 or 2 key on the Keypad
repeatedly until the desired brightness is achieved.
16
Flashes: When receiving print
data.
Lights: While printing.
Lights (Red):
When the machine stops due to
the following condition(s):
●
No paper in the selected tray
or toner has run out.
●
Paper has misfed, etc.
Lights (Orange):
When the machine alerts of the
following condition(s):
●
No paper in the Tray. (Tray is
not selected)
●
Toner is getting low, etc.
Flashes: When the machine is
in operation.
Setting for the Copy
Function
(See page 17)
Setting for the Scan/Email
Functions
(See page 18)
Warning Indications
When the following Warning Indications
appear, correct the problem according to
the displayed message and instructions in
this manual.
Flashes: The machine may stop operating.
To continue using the machine
temporarily, press any key.
Call Service
Periodical service is required.
Call the authorized Panasonic
dealer.
Add Paper
Add paper to the Paper Tray or
Sheet Bypass.
(See pages 76 to 77)
Add Toner (Error Codes : U13)
Replace the Toner Cartridge.
(See pages 78 to 79)
Full Waste Toner (Error Codes :
U14)
Replace the Toner Waste
Container. (See pages 82 to 83)
Setting for the Facsimile/
Internet Fax Functions
(See page 19)
Setting for the Printer Function
SD Card Print (See pages 40 to 43)
and Others
Refer to the Document Management
System (Printer Driver) of provided
CD-ROM.
To Brighten To Darken
Clear 1 Clear
and
2
and