Panasonic Workio DP-C305 Operating Instructions Manual page 11

Handling
■ Control Panel
Do not lift or lean against the Control Panel. The Control
Panel can be broken which could result in injury.
■ Power Switch
●
Used to turn ON or OFF the Main Power Switch on
the rear side of the machine and to turn ON or OFF the
Power Switch on the left side of the machine.
Follow this procedure when turning OFF the Main
Power of the machine:
- Turn OFF the Power Switch on the left side of the
machine, wait a few seconds, and then turn OFF
the Main Power Switch on the rear side of the
machine.
●
If you are not going to use the machine for long
periods of time, turn OFF the machine using the
procedure above.
●
Do not turn OFF the Power Switch on the Left Side
of the machine, or open the Front Cover during
copying/printing.
Main Power
Switch (Rear
Side)
ON ( )
OFF ( )
■ Auto Reset Time
The initial setting for Auto Reset Time is 1 minute.
If you do not touch any key for 1 minute, the Touch
Panel Display will return to the initial screen of the
active function automatically. When reaching 20
seconds before resetting, the "Continue?" screen is
displayed to allow you to extend the auto reset time
for another 1 minute.
If you wish to change the Auto Reset Time, consult
with your Key Operator.
■ Dept. (Department) Code
When the Department Counter function is set up, the
Dept. (Department) Code input screen is displayed on the
Touch Panel Display. A registered Department Code (1 to
8 digits) is required to gain access to each secured
function, or the secured Copy/Scanner function(s) cannot
be used. Please consult with the Key Operator regarding
the Department Code(s) for the desired function.
How to enter the Dept Code:
Input a registered department code (1 to 8 digits).
Select "OK".
■ Maximum Copies Limitation
After setting the maximum allowed number of copies
for each department, consult with your Key Operator
when the total copy count reaches the designated limit
and the message appears on the Touch Panel Display.
■ Auto Image Density/Color Registration Adjustment
Functions
This machine executes the following automatic
adjustment periodically (approximately every 105
copies or print jobs). During the automatic adjustment
process, copy job/print job will stop or jobs will be
waited approximately 20 seconds.
(1) Auto Image Density
(2) Color Registration Adjustment
■ Energy Saver (Power Save Mode, Sleep Mode)
You can set the machine to the Power Save mode or
Sleep mode while the machine is not in use. In Power
Save mode/Sleep mode, the Energy Saver key
Power Switch
flashes or lights. Press the Energy Saver key to
(Left Side)
return the machine to its former operating screen. For
more details, refer to General Settings (Key
ON ( )
Operator Mode) in the Operating Instructions (For
Function Parameters) of provided CD-ROM.
OFF ( )
●
It is normal operation that the machine makes sounds
when switching into the Power Save mode.
Power Save
Sleep Mode
●
Press the Energy Saver key while the machine is in
the Sleep mode. The pop-up screen will be displayed
while machine is warming up to ready.
■ PCMCIA/PC Card Slot
PCMCIA/PC Card Connector inside the PCMCIA/PC
Card Slot is not supplied by Limited Power Sources.
To adjust the print density even.
To adjust the color registration.
Energy Saver key
Flashes: Power Save Mode
Lights : Sleep Mode
(Touch Panel Display
will be unlit)
Modes Warm Up Time
Approx. 15 sec.
Mode
Approx. 15 sec.
11