Operation - Kärcher Puzzi 30/4 User Manual

Note: For considerate treatment of the en-
vironment use detergent economically.
Fill up fresh water reservoir
 Remove the lid of the fresh water tank.
 Fill the cleaning solution into the fresh
water tank up to the 1/1 marking (ap-
prox. 7.9 gal/30 litres) of the filling level
indicator.
 Reinstall the lid of the fresh water tank.
Replacing the carpet adapter
 Push the unlocking device of the floor
nozzle on one side.
 Swivel out and remove the carpet
adapter.
 Insert a new carpet adapter and snap
the locking device in place.

Operation

Fold the push handle in/out
 Loosen the fastening screws of the
pushing handle and adjust the pushing
handle.
Turning on the Appliance
 Plug in the mains plug.
 Set rotary switch to spraying. Spray
pump is switched on.
 Set rotary switch to vacuuming. Suction
turbine is switched on.
 Set rotary switch to spraying/vacuum-
ing. Spray pump and suction turbine are
switched on.
ATTENTION
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
 Operate the lever on the manifold in or-
der to spray the cleaning solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Note: The suction air flow is interrupted by
the float if the wastewater container is full.
10
Cleaning
Turn off the appliance
 Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
 Pull out the mains plug.
Unlocking the bonnet
Illustration
 Unlock bonnet, in order to do so, fold up
the carrying handle of the wastewater
container by 90° Bonnet can be
opened.
Dismantling the bonnet
 Unlock the bonnet.
Illustration
 Swivel the bonnet backwards by 180°
and pull it out.
Note: Be careful when inserting the
bonnet, so that the guide pins do not get
damaged.
Empty wastewater container
 If the wastewater container is full,
switch off the appliance. In order to do
so, set the rotary switch to 0/OFF.
 Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
 Remove the wastewater container from
the appliance and drain it.
Empty the fresh water reservoir
 Switch off the appliance, in order to do
so, set the rotary switch to 0/OFF.
 Shortly activate the lever on bender to
decrease the pressure.
 Separate bender from the spray/suction
hose.
 Remove the lid of the fresh water tank.
 Insert the suction hose into the fresh
water reservoir.
 Set rotary switch to vacuuming. Suction
turbine is switched on.
 Empty the fresh water reservoir and
switch the appliance off.
 Empty the wastewater reservoir.
– 3
EN