Table of Contents
Advertisement
Flexible Arm Installation
This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
•
Follow the instructions provided by the manufacturer of the display mount.
•
To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See page 25 for details. Remove the monitor stand before mounting.
* Contact your dealer for more information.
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Figure S.1).
Be sure to not apply any stress or pressure to the integrated front sensor.
To avoid this, lay the monitor face down on a desk or table with the integrated
front sensor, situated off the edge (Figure S.1).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the
arrows (Figure S.1).
5. Lift up the stand to unhook it from the monitor (Figure S.1).
The monitor can now be mounted using an alternate method.
Reverse the process to reattach stand.
NOTE:
Handle with care when removing monitor stand.
Mount the Flexible arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how Remove Monitor Stand for
Mounting to remove the stand.
2. Using the attached 4 screws, attach the arm to the monitor
(Figure F.1).
Caution: Use ONLY the screws (4 pcs) that are included, M4 size
screws (Length: thickness of bracket and washer +
5-7 mm) when mounting to avoid damage to the monitor
and stand. To fulfi l the safety requirements the monitor
must be mounted to an arm which guaranties the
necessary stability under consideration of the weight of
the monitor. The LCD monitor should only be used with
an approved arm (e.g. TUEV GS mark).
Unit
Mounting
Bracket
Washer
Screw
5-7 mm
Thickness
of bracket
and washer
NOTE:
Tighten all screws.
(recommended Fasten Force: 98 - 137N•cm)
100 mm
Weight of LCD assembly: 4.8 kg
English-11
Figure S.1
100 mm
Figure F.1
Advertisement
Table of Contents
