Section 2 - Rigging Installation - Pro Boat Endeavor Owner's Manual

Section 2 – Rigging Installation
13. Locate the jib sail boom. The end of
the jib boom with the cleat should be on
the top and nearest the front of the boat.
Pass the rigging line from the front of the
jib sail into the hole on the end of the
boom.
14. Position the line so the distance
between the boom and sail is between
3/4-inch and 1 / -inch. Secure the excess
1
4
line by wrapping it around the cleat and
placing the end of the line in the notches
of the cleat.
15. Repeat Step 17 for the other end of
the jib sail.
: The jib boom will be parallel to
Hint
the bottom of the jib sail once Steps 17
and 18 are complete.
16. Carefully unwrap the bow rigging
cable marked "A." Attach the rigging cable
to the fitting at the bow of the boat
marked "A."
17. Carefully unwrap the stern rigging
cable marked "B." Attach the rigging cable
to the fitting at the stern of the boat
marked "B."
7