Installing The Trimplate; Installing The Stylus And Holster - VeriFone MX 880 Installation Manual

Installing the
Trimplate
Installing the
Stylus and Holster
6
Reinstall the compartment cover and door screw.
Figure 10 Reinstalling the Compartment Door and Screw
The MX 800 Series terminal can be fitted with interchangeable trimplates to
customize the appearance of the terminal. Trimplate installation for the MX 880
and MX 870 is explained below. Trimplates for the MX 860, MX 850, and MX 830
are snapped straight down and are not rocked into place.
1
Insert the trimplate by lining up the three notches of the face plate into the
unit.
2
Firmly snap the top part of the trimplate to secure it.
Figure 11

Installing the Trimplate

There are two types of styluses, wide and thin, and each has its own holster. Use
the following steps to install the stylus its holster.
1
Turn the MX 800 Series terminal over and locate the two screw holes for
attaching the holster. Do one of the following:
•
For the thin stylus holster, route the stylus cable through a channel in the
holster and then attach the holster using the two screws. The cable should
be in the channel between the holster and the terminal.
MX 800 S I
ERIES NSTALLATION
15
G
UIDE