Maintenance; Pro Mini Generator - Hensel Pro Mini 1200AS User Manual

User Manual Pro Mini 1200 AS Power Pack
4:
RC/CH
TEST
38
Pressing button 4 of the Pro Mini 1200 AS Power Pack
activates the built-in Radio Receiver (Control LED lights up).
Repeated pressing (> 3 sec) switches to the mode for working
channel selection: On the LED display 5 appears ‚CH' and the
number of the currently chosen working channel (1, 2, or 3).
Turning dial 8 allows to scroll between the channels. Remains
the setting of the working channel unchanged for more than 3
seconds, the channel is selected and the display changes to
flash power setting.
By striking the
shutter flashes can be triggered either selectively depending
on the working channel selected or all flash units together
when the option ,All' was selected on the Radio Transmitter. In
total, 3 working channels are available.
Besides flash triggering there are also options for adjusting the
flash power and modeling lamp available:
(1) Pressing button 23 and 24 allows to decrease (23) and
increase (24) the flash power in 1/10 increments,
respectively.
(2) By pressing button 25 for longer than 3 seconds the
modelling lamp can be switched ON or OFF.
All these parameters go either for all flash units or the selected
working channel.
For increasing the range, the antenna of the Pro Mini 1200
AS power pack can be exchanged by a more sensitive
one.
8

Maintenance

Pro Mini Plus Generator
Pro Mini 1200 AS power pack is in need of little maintenance
by the user. The unit should be dry cleaned from dust from time
to time. Before cleaning switch the unit off and separate the unit
from all connected appliances (Flash Heads, Charging Units).
Caution:
Under no circumstances is any part of the equipment to be
opened. The equipment is not user serviceable and there is
dangerous high voltage. In the event of difficulty notify your
dealer.
„Test" key 27 or by releasing the camera
HENSEL Studiotechnik