Acclimatizing; Positioning; Mains Connection - Hensel Pro Mini 1200AS User Manual

User Manual Pro Mini 1200 AS Power Pack
30
Heating
Due to the modeling and flash light, each power pack and
flash head emits heat. This can heat up the parts of the unit to
a dangerous level. Therefore make sure, that power packs
and lamp heads are located far enough from inflammable
props to avoid inflaming them. Take care for sufficient air
supply and make sure that ventilation slots of power packs
and flash heads are kept free.
Do not operate power packs and flash heads unattended.
Due to the danger of overheating, the modeling light should
never be operated at full power for more than 20 minutes.
Then adequate cooling should be provided for. The modeling
light should never be used for lighting up the studio but only as
an assistance when focusing or determining the light guiding
and shadow details of the flash.

Acclimatizing

When moving power pack from one climatic zone to the next,
the appliance should stand in the room, in which it will be
operated, for some time before starting it up. This prevents
internal shortcuts, which might occur by condensing water.

Positioning

Pro Mini power packs can be operated standing face up.

Mains connection

The type label can be found on the bottom of the appliance.
Multivoltage Version
The power pack adjusts itself for different main voltages.
Flash power packs must only be connected to mains
outlets with ground connection.
Insert the plug of the provided power cable into the mains
connector 1 and then connect the cable to the mains outlet.
HENSEL Studiotechnik