Switching On And Off; Synchronization - Hensel Pro Mini 1200AS User Manual

2:
ON/OFF
14:
SYNC
13
9:
SLAVE
15:
TEST
HENSEL Studiotechnik
Operation Pro Mini Power Pack

Switching ON and OFF

By pressing main switch 2 the power pack will be turned on and
off, respectively.
Synchronization (flash triggering)
Synchronization by cable
The Pro Mini 1200 Power Pack can be connected via the
synchronisation socket 14 to the camera using the provided
synchronization cable.
The synchronization circuit is made up of state-of-the-art semi-
conductor technology and enables secure triggering of the flash
even with older cameras with mechanical contacts.
Due to the many different electronical circuits in cameras for
controlling synchronization, we cannot take any liability for
possible damage to cameras triggering flashes. Please contact
the camera manufacturer before using an unusual camera.
Synchronization by slave
The built-in slave 13 can trigger the power pack. Triggering is
then effected by an „incoming" flash, which was emitted by
another flashlight. This mode of operation is switched on using
push-button 9 till LED indicator lights up. The slave is an
impulse photocell. It can only operate, when the triggering flash
has a higher f-stop than the ambient light. Please be aware that
the ambient light that strikes the slave may never be too strong.
If this cannot be avoided, please switch off the slave and
release the flash by cable or radio signal.
Synchronisation mit Strobe Wizard Transmitter
See information on pp. 37
Test flash
By pressing the TEST button 15 test flashes can be released.
Flash power distribution of output sockets
Operation of the battery powered flash unit is possible in
symmetrical and asymmetrical mode.
User Manual Pro Mini 1200 AS Power Pack
33