Audio; Slow Charging; Test Flash; Trouble Shouting - Hensel Pro Mini 1200AS User Manual

6:

AUDIO

3:
SLOW
15:
TEST
5, 11:
LED-Displays
HENSEL Studiotechnik
Audio
Readiness to flash after charging is signalled with a tone. This
tone can be turned on (control LED lights up) or off using the
AUDIO switch 6.

Slow charging

By pressing button 3 the charging time can be doubled. This
provides more flashes per accumulator charge.

Test flash

By pressing button 15 test flashes can be released.
The green light of the LED control lamp 12 signals readiness to
flash.
Trouble shooting
The following errors are shown on both LED Displays 5 and 11:
E1: Overheat
E2: Overcharge
E3: No ignition
Radio flash trigger and power control system
Strobe Wizard Plus
The Pro Mini 1200 AS Power Pack is equipped with a built-in
Radio Receiver. For flash triggering and flash power control the
power pack comes with the Radio Transmitter Strobe Wizard
Plus.
The radio technology allows you to operate independent of
environmental factors like ambient light that interfere with the
receiver. You can even trigger flashes if your flash units are
out of sight and over long distances (> 40 m free visibility).
The Strobe Wizard Plus transmitter has no built-in main switch
for switching the unit ON. The radio transmitter has to be
connected with the camera using the provided synchronization
cable (use sync socket 28) or by attaching the transmitter to
the Hot Shoe of the camera, respectively. If it is connected to
the Hot Shoe the unit must be carefully tightened using locking
screw 29. Using the lateral sliding switch 26 the working
channels 1, 2, or 3 can be selected or switched to ‚All'.
User Manual Pro Mini 1200 AS Power Pack
37