Installation; Lamp; Inserting Or Replace The Lamp - ProLights LUXOR User Manual

8

- 2 - INSTALLATION

2.1 LAMP

We recommend that you use MSD Platinum 5R 189W (cod. 800198). Make sure that the lamp you use is
compatible with local voltage. If the lamp is operated with a voltage surpassing its nominal operating volt-
age, it can be damaged or its service life reduced considerably.
2.2 INSERTING OR REPLACING THE LAMP
Please proceed as follows to replace the lamp (the lamp gets very hot during operation, so let it cool
down sufficiently before you attempt to dismount it! Lamps that have been damaged must be replaced
immediately).
1. Disconnect the power plug the unit, Unscrew the two screws X, Y (see fig.4), open the lamp cover, turn
it to the position as the diagram shown.
2. Hold the base of the lamp, anticlockwise turn until it is parallel to the groove.
3. Do not touch the lamp's envelope with bare hands. Should this happen, clean the bulb with a cloth
soaked in alcohol and dry it with a clean, dry cloth. Inset a new lamp follow the groove, turn it clockwise
to fix the lamp.
4. Screw the screws X, Y to fix the lamp cover.
X
LUXOR
WARNING!
Disconnect the fixture from AC power before re-lamping.
Hot lamp! Risk of fire ! Protect hands and eyes.
Wait at least 20 min. before opening the covers
and moving lamps from the fixture.
Maximum room temperature ta=40°C
Not for domastic use.
Remove the screws
and
for re-lamping
Y
Fig.4
X
Y