ProMinent gamma/l Installation And Configuration Manual page 40

Function blocks for gamma/L and Sigmas
Interfaces of the function block
Interfaces
ixStart_Stop
ixStartBatch_Or_Contact
ixBatchContactMemory
ixReset
ixFault_Lock
ixResetStrokeCounter
ixResetStrokeQuantity
ixFlowControl_OnOff
iyMode
40
A more detailed explanation of the functions that are
assigned to the slots is provided in the "Supplemental
manual for gamma/ L and Sigma versions with PROFIBUS
Type Description
Bool If a 1 is applied on this input and if there is no fault, the
pump will be activated.
If the pump does not run or is not at a standstill the fol‐
lowing causes are possible:
PROFIBUS
n
Pump is not in PROFIBUS
n
PROFIBUS
n
Configuration is not correct
n
Pump is manually set to stop
n
Setpoint is on 0% (irSetpoint_0_100)
n
ixFault_Lock = 1 and oxError = 1 or oxProfibus = 1
n
Use Profibus Workaround
n
Adapt iiCycle_Error
Bool Mode batch - iyMode = 1 pump starts batch mode at a
positive flank
Bool 0 = Memory function is switched off
1 = Memory function is active
Bool Resets the bit messages oxWarning, oxError and oxEr‐
rorProfibus. Resets the pump (positive flank sent).
Bool If 0, then the pump does not include a locking mechanism
for stored faults.
Logical link:
Start pump = ixStart_Stop
i.e. because the faults oxError and oxErrorProfibus
require acknowledgment, the pump automatically starts
up again if there is a fault on both sides.
If 1, then the pump does not include a locking mechanism
via fault messages oxError or oxErrorProfibus.
Logical link:
Start pump = ixStart_Stop & oxError = 0 & oxErrorPro‐
fibus = 0
i.e because the faults oxError and oxErrorProfibus
require acknowledgment, the pump does not automati‐
cally start up again if there is a fault on both sides.
Bool At a positive flank the stroke counter will be reset.
Bool At a positive flank the quantity counter will be reset.
Bool 0 = Metering monitor off
1 = Metering monitor on
Prerequisite is an installed metering monitor.
Byte 00 = Manual
01 = Batch
02 = Contact
03 = Analogue
® is faulty
mode
®
® address is not correct
".
®