Table of Contents
Advertisement
Integrating the device and the function block into your own project
Fig. 12: Connection of the Master System to the delta via the subnet (graphic presentation in the Hardware Configurator)
16
5.
"Address" set the PROFIBUS
Under
or Sigma - see supplemental instructions delta with PROFIBUS
[OK] .
and click
If this address is not displayed (already allocated),
enter a new address. Then enter this address on your
actual gamma/ L or Sigma, as well.
ð The Hardware Configurator will then connect the gamma/ L or
Sigma to the PROFIBUS
the subnet, which the Hardware Configurator displays in this
manner:
In the lower window area (red box) the individual slots and their
I-addresses and O-addresses (input addresses and output
addresses) of the gamma/L or Sigma are displayed.
6.
If necessary, adjust the I-address ranges and O-address ranges. To
do this double click on the appropriate row.
ð A window will open.
7.
Here, enter the desired, changed address range and click
The Hardware Configurator will supplement the
address range automatically.
The Hardware Configurator prevents the address from
being allocated twice. It handles I-addresses and O-
addresses separately.
8.
Save the addresses via the special diskette symbol
the toolbar.
®
that is set on your gamma/ L
Master System (red box, right) via
®
with "0110" in
®
-
[OK] .
Hide quick links:
Advertisement
Table of Contents
