Tiger JAX-S10U Operating Instructions Manual page 18

Removing and attaching the steam cap
„ Removing the steam cap
1
Insert your finger into the hole
in the lid and lift the steam cap
upwards.
Steam cap
2
Turn the inside portion of the
assembly as shown in the
illustration to loosen it.
3
Lift up on the inside portion to
separate it from the cap.
34 34
„ Attaching the steam cap
1
Set the inside portion of the
assembly on top of the cap
portion.
2
Turn the inside portion of the
assembly as shown in the
illustration to tighten it.
Align the markings.
3
Attach the steam cap back in
the lid.
„ Installing the steam cap gaskets
If the gaskets are loose, refer to the illustration and set them securely into place. If the gaskets are not set
securely, they can become loose and may result in problems due to steam leaking out, etc.
Steam vent
gasket
Cleaning the lower heating plate
Water drops may fall from the inner lid during cooking and cause the surface of the lower heating plate to
become dirty. This will not affect the performance of the rice cooker but, if you would like, you can clean the
heating plate using the following procedure.
1
Add a bit of standard kitchen
cream cleanser to a nylon
scouring sponge, and remove
the surface dirt.
2
Wipe clean with a damp paper
towel or cloth.
O-ring
Nylon scouring sponge
Heating plate
35 35