128
Chapter 6: DH emulation
Ethernet setup commands
The following commands are designed to set the required printer internal parameters for Ethernet operation. The
commands can be used only in the Flash download (boot) mode. See Chapter 3 for default setup.
Restore default settings
ASCII
US BS NUL
Hexadecimal
1F 08 00
Decimal
31 8 0
Restores the Ethernet settings to the preset values.
Default settings are:
IP address:
Net mask:
Gateway:
Raw TCPIP port 9001:
Telnet Daemon:
LP Daemon:
Bootp:
DHCP:
Inactivity timeout:
Keep alive pings:
Set IP address
ASCII
US BS SOH n1 n2 n3 n4
Hexadecimal
1F 08 01
Decimal
31 8 1
Default:
192.0.0.192
Sets the IP address value specified by the values of n1 to n4.
Set Net Mask
ASCII
US BS STX n1 n2 n3 n4
Hexadecimal
1F 08 02 n1 n2 n3 n4
Decimal
31 8
2
Default:
0.0.0.0
Sets the Net Mask value specified by the values n1 to n4.
Set Gateway
ASCII
US BS ETX n1 n2 n3 n4
Hexadecimal
1F 08 03 n1 n2 n3 n4
Decimal
31 8 3
Default:
none
Sets the printer to the gateway having the IP address value specified by the values n1 to n4. A gateway, even when the
printer is on another subnet, is not always needed.
The printer initiates no connection and obtains the gateway address from the host packets.
A776 (B780) Programming Guide
192.0.0.192
(in use after boot timeout of two minutes)
0.0.0.0
(default mask of selected IP is used)
none
active
enabled
disabled
disabled
enabled
enabled
disabled
n1 n2 n3 n4
n1 n2 n3 n4
n1 n2 n3 n4
n1 n2 n3 n4
A776-PG00001 D 07/13