Set Raw Tcpip Port 9001; Lp Daemon; Telnet Daemon; Bootp - CognitiveTPG A776 ColorPOS Programming Manual

Set raw TCPIP port 9001

ASCII
US BS EOT n1 n2 n3 n4
Hexadecimal
1F 08 04 n1 n2 n3 n4
Decimal
31 8 4
n1 = 0: disabled
n1 = 1: enabled
Default:
enabled
Sets the port where the printer will look for raw tcpip communications.

LP Daemon

ASCII
US BS ENQ n1
Hexadecimal
1F 08 05
Decimal
31 8 5
n1 = 0:
disabled
n1 = 1:
enabled
Default: disabled
Enables or disables the printer LP Daemon. The LP listens on port 515.

Telnet Daemon

ASCII US BS ACK n1
Hexadecimal 1F 08 06
Decimal 31 8 6
n1 = 0:
disabled
n1 = 1:
enabled
Default:
enabled
Enables or disables the printer Telnet server. The Telnet server listens on port 23.

BootP

ASCII
US BS BELL n1
Hexadecimal
1F 08 07
Decimal
31 8 7
n1 = 0: disabled
n1 = 1: enabled
Default:
disabled
Enables or disables the use of BootP at power-up to obtain an IP address. BootP is a subset of DHCP.

DHCP (auto-configuration)

ASCII
US BS BS n1
Hexadecimal
1F 08 08 n1
Decimal
31 8 8
n1 = 0:
disabled
n1 = 1:
enabled
Default: enabled
Enables or disables the use of DHCP at power-up to obtain an IP address. If no address is found within two minutes,
DHCP obtains the default IP address.
A776-PG00001 D 07/13
n1 n2 n3 n4
n1
n1
n1
n1
n1
n1
n1
Chapter 6: DH Emulation
A776 (B780) Programming Guide
129