Advertisement
Quick Links
Advertisement
Related Manuals for gofanco G4-0014A
Summary of Contents for gofanco G4-0014A
- Page 1 ® HDMI HDbitT CAT5e/6 Extender with IR - 120m P/N: HDbitTExt G4-0014A...
- Page 2 Congratulations for owning a gofanco product. Our products aim to meet all your connectivity needs wherever you go. Have fun with our products! Please read this manual carefully before first use. If you need more information about our products, please visit www.gofanco.com.
-
Page 3: Specifications
Introduction gofanco HDMI HDbitT CAT5e/6 Extender with IR - 120m (part# HDbitTExt) extends HDMI signals over one Cat5e/6 cable up to 120m (394ft) with IR support. Specifications Output Signal HDMI Protocol HDbitT Resolution Up to 1080p Transmission Up to 120m (394ft) - Page 4 Layout Reset IR Out HDMI In Figure 1: Transmitter (TX) - HDMI Device Input • HDMI In: Connect your HDMI source here with an HDMI cable (cable not included) • IR Out: Infrared 3.5mm socket. Plug IR Blaster extension cable here •...
- Page 5 • Power Jack: Connect the included 5V DC power adapter here • Power LED: On when the Transmitter is powered • RJ45: Link to the Receiver's RJ45 via a Cat5e/6 cable • Activity LED: Blinks during data transmission • Link LED: On when the Cat5e/6 cable is connected/linked properly to Transmitter's and Receiver's RJ45 Link LED Power LED...
- Page 6 Reset IR In HDMI Out Figure 4: Receiver (RX) - HDMI Display Output • HDMI Out: Connect to your HDMI display here with an HDMI cable (cable not included) • IR In: Infrared 3.5mm socket. Plug IR Receiver extension cable here •...
- Page 7 IR Extenders Figure 6: IR Receiver Figure 5: IR Blaster (Connect to Receiver RX) (Connect to Transmitter TX) • IR Blaster: Plug into the Transmitter's IR 3.5 socket to emit IR signals received from the IR Receiver end. • IR Receiver: Plug into the Receiver's IR 3.5 socket to receive IR signals from a remote control for the HDMI device connected to the Transmitter.
-
Page 8: Hardware Installation
Hardware Installation Note: To achieve optimal performance, a CAT6 cable is recommended. 1. Power off all devices including your HDMI source and display. 2. Connect your HDMI source to the Transmitter's HDMI IN connector. 3. Optional: Connect the IR Blaster extension cable to the Transmitter's IR Out. - Page 9 Application 1. Single output: Extend HDMI signals up to 120 meters over one CAT5e/6 cable. CAT5e/6 cable HDMI Out HDMI IN Figure 7 2. Multiple outputs: Extend and split using network router/ switch. One Extender (TX) to several Receivers (RX) HDMI Out HDMI IN Receiver...
- Page 10 3. Cascade: Unlimited extension with network router/ repeater. CAT5e/6 cable HDMI IN Transmitter Switch*N Switch HDMI Out Receiver...
- Page 11 FAQ & Solutions Q: The TV displays "Waiting for connection..." on the bottom-right corner: A: 1) Check whether the power adapter of Transmitter (TX), Receiver (RX) or Network Switch (if used) is connected. 2) Make sure the Network cable (CAT5e/6) is firmly connected between TX and RX.
- Page 12 ® Thank you for choosing gofanco www.gofanco.com...