KERN CGB Operating Instructions Manual page 39

Item
1 Weighing pan
2 Battery compartment
(below the control unit)
3 Control unit
4 Foot
5 [UNIT] key: Toggles between
2 weight units or to counting mode
6 [START] key: starts measurement
of the average piece weight
7 Selector: selects reference sample
quantity
8 [OK] key: saves reference sample
quantity
9 [DELETE] key: cancels operation
This key is generally used for the
following:
– End counting
– Cancel a calibration/adjustment
routine in progress
10 [PRINT] key: generates a printout
This key sends displayed values via
the built-in data interface to an
on-line Data Printer or to a computer.
11 [TARE] key: tares (subtracts weight)
The weight of an empty container
is subtracted so that the net weight
of a sample in the container is
always shown afterwards.
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
Item
12 ( key: Sets the display to zero.
Zeroing is only allowed within
the ± 2% range of the balance's
maximum capacity.
13 [ON/OFF] key: Switches the
display on or off. (The balance
remains energized in the standby
mode – depending on the menu
setting.)
14 Display: average piece weight
15 Weight display in the basic unit
selected
16 Shows that a value is in the tare
memory
17 Symbol for standby operation
18 Symbol for zeroing
19 "Busy" symbol
20 Weight unit or piece count (pcs)
21 Manufacturer's label
22 DC jack
23 Data interface port
24 Main display
39