KERN IFB-BA-e-1012 Operating Instructions Manual page 26

Overview:
Menu block Menu item
Main menu Sub-menu
PO CHK SET H
Weighing with
SET LO
Tolerance limits,
BEEP
see chpt. 7.6
P1 COM MODE
Interface
parameters
BAUD
Pr
PTYPE
P2 CAL COUNT
DECI
DUAL
CAL
GrA
P3 OTH
LOCK
s. Kap. 7.9 / 7.10
ANM
26
Available settings / definition
Upper limit, for entry see chpt. 7.6
Lower limit, for entry see chpt. 7.6
Acoustic signal turned off for weighing with
no
tolerance limits
Acoustic signal sounds if load is within tolerance
ok
limits
Acoustic signal sounds if load is beyond
ng
tolerance limits
CONT Continuous data output
One output for stable weighing value
ST1
Continuous data output of stable
STC
Weighing values
PR1
Output after pressing
Manual add-up, see chpt. 7.7
PR2
After pressing
added to summation memory and issued.
AUTO
Automatic add-up, see chpt. 7.8
This function is used to automatically add and
send individual weighing values to the
summation memory whilst weighing instrument
is being unloaded.
ASK
Remote control instructions:
R, "read"
T, "tare"
Z, "zeroing"
Available baud rate 600, 1200, 2400, 4800, 9600
7E1 7 bits, even parity
7o1 7 bits, odd parity
8n1 8 bits, no parity
tPUP Standard printer setting
LP50 Not documented
Display internal resolution
Position of the decimal dot
Weighing scale type, capacity and readability (non-
verified) or verification value (verified).
Adjustment, see chpt. 6.5
Not documented
on Keyboard interlock enabled
off Keyboard interlock disabled
on Animal weighing enabled
off Animal weighing disabled
, weighing value will be
IFB-BA-e-1012