Saving Uefi Configuration Settings; Booting And Installing The Operating System; Operating System Is Loaded Onto The Server; Operating System Is Not Loaded Onto The Server - HP Integrity rx2800 i2 Installation Manual

To perform more advanced operations, press S to launch the UEFI Shell.
To view the iLO LAN configuration, press I to launch the iLO Setup Tool.

Saving UEFI configuration settings

You can configure other UEFI settings at this time. For more UEFI configuration options, see the HP
Integrity rx2800 i2 User Service Guide at http://www.hp.com/go/integrity_servers-docs.

Booting and installing the operating system

From the UEFI Front Page prompt, you can boot and install in either of two manners:
If your OS is loaded onto your server, see
(page 17).
If the OS is not installed onto your server, see
(page 17).

Operating system is loaded onto the server

If the OS is loaded on your server, normally UEFI automatically boots to the OS. If the UEFI Front
Page is loaded, press ENTER to start auto boot, or B to select a specific boot option for your OS.
Use your standard OS login procedures, or see your OS documentation to log in to your OS.

Operating system is not loaded onto the server

There are three options on how to load the OS if it is not loaded onto your server.
For instructions on loading an operating system onto a server, see the HP Integrity rx2800 i2 User
Service Guide at http://www.hp.com/go/integrity_servers-docs.

OS login prompt

If your server is at the OS login prompt after you establish a connection to the server, use your
standard OS log in procedures, or see your OS documentation for the next steps.

Powering on and powering off the server

Power states

The server has the following power states:
Standby power
Full power
Off
For details about server power states, see
NOTE: If the power restore feature is set to Always On through the iLO 3 MP PR command, the
server automatically powers on to the full power state when the power cord is plugged in to the
server.

Powering on the server

Power on the server to full power using the following methods if the server is in the standby power
state:
iLO 3 MP PC command
Power button
"Operating system is loaded onto the server"
"Operating system is not loaded onto the server"
Table 2 (page 13).
Powering on and powering off the server 17