Attaching The Bezel Cover - HP Integrity rx2800 i2 Installation Manual

2. Hold the pedestal component flush against the server.
3. Slide the pedestal component forward until it locks into place.
Figure 3 Installing the pedestal bottom piece
4. Stand the server up on the bottom piece of the pedestal kit that was just installed so the server
is in the vertical position.
CAUTION:
Without the feet installed, the server might tip over easily. Be careful when working near the
server to avoid tipping it over.
5. Align the holes in the pedestal top piece with the posts on the server.
NOTE:
makes the hole appear partially blocked.
6. Hold the pedestal top piece flush against the server.
7. Slide the pedestal top piece forward until it locks into place.
8. The top and bottom pedestal kit pieces are now in place.

Attaching the bezel cover

To attach the bezel cover:
1. Attach the bezel cover to the front of the server starting from the bottom of the pedestal kit.
2. Push the bezel cover into place against the pedestal kit top piece until the tabs on the bezel
cover snap into place.
The server is heavy. Be careful when lifting it to the vertical position.
One of the holes in the pedestal component contains the locking mechanism. This
Installing the server into a rack or pedestal 9