Attaching The Pedestal Kit Side Pieces - HP Integrity rx2800 i2 Installation Manual

Figure 4 Attaching the bezel Cover

Attaching the pedestal kit side pieces

The pedestal kit right side piece attaches to the top of the server. The top cover of the server might
have ventilation holes in it to enable proper air flow and cooling. The right side piece of the
pedestal kit also has ventilation holes in it to enable the proper cooling and air flow. Follow these
steps to attach the pedestal kit right side piece.
WARNING!
the ventilation holes on the top cover of the HP Integrity rx2800 i2 Server to enable proper cooling
and air flow. Failure to heed this warning causes the server to shut down with an overtemp condition.
To attach the component:
1. Align the posts on the pedestal kit right side piece with the slots in the pedestal kit top and
bottom.
2. Hold the pedestal side flush against the server and slide it toward the front of the server.
10 Installing the server
The ventilation holes in the pedestal kit right side piece must be matched up with