ç Contents
•
Selecting an unprotected access point in step 7 and pressing the
<o> button will display the screen in step 9.
•
Up to 20 access points are listed. If your desired access point is not
listed, press the <v> button and select [Manual Settings] in step 6
on
= 85
to specify the access point manually. Follow on-screen
instructions and enter the SSID, security settings, and the password
(=
97).
•
If WEP security is used and you enter the wrong password in step 8,
when you press the <o> button and then press the <o> button
again after the message, you will go to step 9, but printing is not
possible. Check the access point password and try to connect again,
starting at step 3.
•
On SELPHY, wireless signal strength is indicated by the following
icons.
[
] High, [
] Medium, [
] Low, [ ] Weak, [
87
] Out-of-range