Canon SELPHY CP1200 User Manual page 114

ç Contents
Wi-Fi
Do not use the printer near sources of Wi-Fi signal interference,
such as microwave ovens, Bluetooth devices, or other equipment
operating on the 2.4 GHz band.
Device SSID (network name) not displayed when connecting to
a camera or smartphone
• As the connection method, choose [Direct Connection]
• Keep the printer near the camera or smartphone, without objects between
them.
Access point not displayed on the printer
Cannot connect the printer to the access point
• As the connection method, choose [Via Wi-Fi Network]
• Confirm that the access point is on and ready for communication. For
instructions on how to check, refer to the access point user manual.
•
If there are many access points but the required one is not listed, connect
using WPS (=
• Keep the printer near the access point, without objects between them.
• Confirm that the password is correct, and try connecting again.
• Confirm that the access point channel is between 1 – 11. Instead of auto
channel assignment, it is advisable to specify a channel in this range
manually. For instructions on checking or adjusting the settings, refer to the
access point user manual.
• If the access point filters communication by MAC or IP addresses, on the
access point, register the printer information shown when you check the
settings (= 94). Also try disabling any access point isolation or privacy
separation functions.
For instructions on checking or adjusting the settings, refer to the access
point user manual.
• In WEP networks without DHCP, set the IP address manually
79) or manually (= 87).
114
(= 68, 74).
(= 79).
(= 96).