Table of Contents
Advertisement
1. Remove the protective cap from the fiber-optic cable. See Figure 32.
Figure 32. Removing caps from fiber-optic cables
2. Connect the fiber-optic cable to the installed SFP, as shown in Figure 33.
Figure 33. Connecting cables to the installed SFP
3. Check the LEDs on the RAID controller. When the RAID controller is operating
4. To remove the fiber-optic cables, gently pull the fiber-optic cable from the SFP;
Using LC-LC fibre-channel cables
The LC-LC fibre-channel cable is a fiber-optic cable that you use to connect into
one of the following devices:
v An SFP module installed in an IBM FAStT100
v An SFP module installed in an IBM FAStT EXP100 Expansion Unit
See Figure 34 on page 44 for an illustration of the LC-LC fibre-channel cable.
Fiber-optic
cable
RAID controller
Fiber-optic
cable
properly, the amber Fault LED is off. For information about the status of the
RAID controller LEDs, see Table 11 on page 64.
then replace the protective caps.
Protective cap
SFP module
Chapter 3. Cabling the storage server
43
Advertisement
Table of Contents
