Safety Guide - Handling And Operation; Operation Environment; Machine Handling - Riso EZ5 Series User Manual

REG-ML_EN.book Page 11 Wednesday, September 21, 2011 5:19 PM

Safety Guide - Handling and Operation

This section describes the precautions to be observed when handling the machine. Read this section before operat-
ing the machine.

Operation Environment

Important!:
• Operate the machine under the following appropriate environment conditions.
Temperature range: 15°C to 30°C (59°F to 86°F)
Humidity range: 40% to 70% (noncondensing)

Machine Handling

A
WARNING:
• Do not place water containers or metallic objects on the machine. Fire or electric shock may occur if water or metal-
lic objects fall into the machine.
• Do not use combustible spray and flammable solvent near the machine.
If sprayed gas and flammable solvent contact electronic components inside the machine, fire or electric shock
might occur.
• Do not insert any metallic material or flammable substance into the machine through any opening. This can result
in fire or electric shock.
• Do not remove machine covers. Exposing internal parts may result in electric shock.
• Do not disassemble or rebuild the machine by yourself. This can result in fire or electric shock.
• If the machine emits excessive heat, smoke or foul odor, immediately turn off the POWER, unplug the power cord
and contact your service representative. Failure to do so can result in fire or electric shock.
• If something drops inside the machine, immediately turn off the POWER, unplug the power cord and contact your
service representative. Failure to do so can result in fire or electric shock.
• Never stick your hands or fingers in the openings of the machine during operation.
• Keep loose clothing or long hair away from moving parts to avoid becoming entangled.
• Do not place heavy objects on the machine. The objects might fall and cause injury.
• Contact your service representative before moving the machine.
B
Caution:
• Never insert fingers, etc. into the openings around Paper Feed Tray and Paper Receiving Tray. This can result in
injury.
• Because ink may have stuck to areas around the Print Drum (Cylinder) or inside the machine when the Print Drum
(Cylinder) was removed, be careful not to contact them with your hands or clothes.
When ink has stuck to your hands, etc., wash it off with detergent as soon as possible.
• When you remove paper by inserting a hand inside the machine, be careful not to touch the paper separation hook.
Because the tip of paper separation hook is sharp, it might cause injury.
• Do not open any covers or move the machine during operation.
• Unplug the power cord, if you do not use the machine for a long time.
• The machine has precision parts and driving parts inside. Do not handle the machine in other ways than described
in this manual.
• Do not apply any shock to the machine.
• Do not stand the Print Drum (Cylinder) vertically. Doing so may pollute the floor, etc.
Important!:
• Do not unplug the power cord or turn off the power during operation.
• Be sure to open and close all machine covers gently.
Before Starting to Use
Safety Guide - Handling and Operation
11