Table of Contents
Advertisement
Fall Prevention
Special attention is required when installing the camera to the wall or
ceiling. You should not engage in the installation work yourself. Ask a
professional to do the job. Otherwise, injuries or accidents may occur
if the camera falls.
When installing the camera on a fixer, pan/tilt unit and the like, make
sure to install it firmly using a rotation-preventive hole to prevent fall.
To prevent fall, connect the camera to a section with sufficient
strength (ceiling slab or channel) using a fall prevention wire.
Pay attention to the length, strength, routing and material (insulation
properties) of the fall prevention wire used.
Use the screw (M3 x 6 mm) on the back of the camera for the
installation of the fall prevention wire. Do not use a screw that is
longer than 6 mm as it may damage the internal parts.
6 mm
6mm
2 mm
When mounting the camera to the ceiling, ensure to wear
Note
safety glasses to protect the eye from any falling objects.
RU CT IO
N
SE E IN ST
L
M AN UA
OF F
V ID E O
D/ N AU
TO
ON
O U T
BL C OF
F
CR T
LC D
ON
W ID E- D
FO CU S
OF F
R TY PE
AD JU ST
MO NI TO
2 ON LY
S E T
CL AS S
)
(U TY PE
ER
ED PO W
IS OL AT
GN D
)
(E TY PE
AU X
ON LY
M E N U
DC 12 V
AC 24 V
2
1
Connection/Installation
Fall prevention wire
M3 x 6 mm
E-21
Advertisement
Table of Contents
