Table of Contents
Advertisement
Introduction
Operating Precautions
Storage and Location of Use
Do not install the camera in the following places.
- In a place exposed to rain or moisture.
- In a place with vapor or oil, for example in a kitchen.
- When the ambient temperature rises above or falls below the
acceptable range (from -10 f to 50 f)
- In a place at which corrosive gases are emitted.
- Near a source of radiation, X-rays, strong radio waves or
magnetism.
- In a place, such as vehicle installation, which is subject to vibration.
- In a place with excessive dirt.
Using this unit in the vicinity of the transmitting antenna of a radio or
TV, devices that emit strong electromagnetic waves such as a
transformer or motor, or wireless devices such as a transceiver or
mobile phone may give rise to noises in the image and changes in its
color.
This camera has been designed for indoor use. When using it
outdoors, it is necessary to use an outdoor camera housing
(optional).
Maintenance
Wipe the camera with a dry, soft cloth to remove any dirt.
Do not use benzene or thinner to wipe the camera. Doing so may
melt the surface or cause it to fog. For tough stains, wipe with a
neutral detergent diluted with water, followed by wiping with a dry
cloth.
Replace the IR LED unit every 3 years if it is used for 8 hours per
day.
Energy Conservation
When the camera is not in use for a long time, turn off the power for
safety and energy conservation reasons.
E-12
Advertisement
Table of Contents
