Circuit Breaker Operation; Maintenance; Warranty - Waring 800ES Operating Manual

Tighten container bottom securely before washing.
9. Not for waterjet cleaning.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot materials, the following
precautions and procedures must be observed:
1. Limit the amount of material processed to 1/2 pint (235 ml).
2. Completely remove the measuring cup lid insert before turning on blender. This will allow
venting of the rapidly heated and expanding air present inside container when blender is
running.
3. Always start blending on lowest speed setting, then progress to desired speed.
4. Never stand directly over blender when it is being started or while it is running.

CIRCUIT BREAKER OPERATION

You will find a small, square, red plastic button located on the underside of the motor base of
some models.
This is the reset button for a circuit breaker which prevents the motor from overheating in
case of an overload.
If an overload occurs, the circuit breaker will shut off the motor and cause the button to
protrude slightly from its normal position.
To reset the circuit breaker and resume operation, do the following:
1) SET THE POWER SWITCH TO ITS OFF (0) POSITION.
2) UNPLUG THE POWER CORD FROM ELECTRICAL OUTLET.
3) DETERMINE THE REASON FOR THE OVERLOAD, AND ELIMINATE THE CAUSE (FOR
EXAMPLE: REDUCE THE AMOUNT OF MATERIAL BEING PROCESSED).
4) PUSH THE RED RESET BUTTON BACK INTO ITS NORMAL POSITION.
5) PLUG THE POWER CORD BACK INTO ELECTRICAL OUTLET.
6) RESUME NORMAL OPERATION.
• MOTOR
Not for waterjet cleaning.
The motor requires no greasing or oiling. Sealed-in lubrication gives the unit lifetime
smooth operation.
• POWER SUPPLY CORD
The power supply cord should not be replaced by the end user.
The power supply cord should only be replaced by the manufacturer's authorized importer
(or, in the United States and Canada, by an authorized service center).
For repairs or further questions, please contact the manufacturer's authorized importer (or,
in the United States and Canada, an authorized service center).
For Waring products sold outside of the U.S. and Canada, the warranty is the responsibility
of the local importer or distributor. This warranty may vary according to local regulations.
WARING: This warranty is VOID if appliance is used on Direct Current (D.C.)

MAINTENANCE

WARRANTY

3