Operation - Waring 800ES Operating Manual

1. Before starting, make sure that the blender cord is unplugged and that the switch is set to the
OFF (O) position.
2. Place container assembly on motor base so that it is firmly seated and not tilted to one side.
NOTE: If your blender has a container with a removable base and blade, the following points
must be observed when assembling the container. Refer to Fig. 1:
• Container gasket must be between the blade assembly and the container.
• Container bottom must not be misthreaded onto the container.
• Container bottom must be securely tightened to the container before placing food or liquid in
the container.
• Tighten the container bottom by holding the container upside down and rotating the container
bottom counterclockwise, in the direction of the molded arrow on the underside of the
container bottom.
• Never place the container bottom or the blade assembly on the motor base unless they are
completely attached to the container and securely tightened.
3. Be sure the switch is still in the OFF (O) position, and plug the power cord into a convenient
outlet.
4. Put ingredients into container and cover it. Always add liquid ingredients first, unless otherwise
specified in recipe. Do not fill above MAX line.
5. Set switch to the ON (I), LOW (1) or HIGH (2) POSITION. Always hold container with one hand
when starting, and while blending. Never operate without jar lid in place.
When finished blending, set switch to OFF (O) position.
NOTE: For blenders with timers, turn the timer control knob clockwise to the desired time setting
before starting the motor. If time setting is less than 10 seconds, turn knob past "10", then back
to desired setting.
When switch is set to the desired speed, motor will run. Motor will automatically stop at the end
of the set time, and indicator lamp will light.
When switch is set to OFF (O) position, indicator lamp will
go out.
Turning timer knob counterclockwise to the MANUAL
position disables timer and indicator lamp, allowing
blender to be turned on and off manually.
6. Allow motor to come to a complete stop before removing
container. Never place the container on the motor base or
remove it from the motor base while the motor is running.
7. Remove the container from the motor base and empty the
contents.
8. Wash and dry container after each use. Containers with
removable bottoms should be disassembled before
washing.
• The following parts are dishwasher safe:
containers, stainless steel containers, removable
container bottoms, blade assemblies, and gaskets.
• The following parts are not dishwasher safe and must
be hand washed: plastic containers, container lids,
and measuring cup lid inserts.
After cleaning and drying, reassemble containers with
removable bottoms.
Be sure gasket is between blade assembly and container
as shown in Fig. 1.

OPERATION

glass
2
Measuring Cup Lid Insert
(1 & 2 oz., 30 & 60 ml
Lid
Container
Gasket
Blade Assembly
Container
Bottom
Tighten Counterclockwise
Fig. 1