Yamaha XJR1300SP Owner's Manual page 76

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
6
1. Speedometer gear unit retainer
2. Lift the wheel up between the fork
EAU01758
legs.
NOTE:
_
Make sure that the slot in the speedom-
eter gear unit fits over the retainer on
the fork leg.
_
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Push down hard on the handlebar
several times to check for proper
fork operation.
6. Install the brake calipers by install-
ing the bolts.
NOTE:
_
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
_
7. Install the brake hose holders by
8. Install the front wheel axle pinch
9. Connect the speedometer cable.
6-33
installing the bolts.
bolt, and then tighten the wheel
axle, pinch bolt and brake caliper
bolts to the specified torques.
Tightening torques:
Wheel axle:
73 Nm (7.3 m·kg)
Front wheel axle pinch bolt:
19 Nm (1.9 m·kg)
Brake caliper bolt:
40 Nm (4.0 m·kg)