Draining - NewAir AC-12200E Owner's Manual

IMPORTANT !
1. To prolong the compressor's life, after switch-off of the unit, please wait for 3 minutes (at
least) before re-switch.
2. The cooling system will switch off if the ambient temperature is lower than the set one. The
fan, however, keeps working at the set level. If the ambient temperature rises above the
selected level, the cooling will return to work.
DRAINAGE
When the unit is operating in Cooling or Dry mode, humidity extracted from the air is collected in
an internal tank. If the tank reaches full, the compressor and motor cut out automatically. At the
same time, the "Water Full" indicator comes on. An alarm will also sound. When the tank is full,
carry out the following instructions:
1. Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug
from the drain hole and allow the water to
drain out.
4. When the container is almost full, replace
the rubber plug in the drain hole and
empty the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should
not be flashing.
Should you prefer to use the appliance without having to empty the tank every so often, proceed
as follows:

Remove the drain knob and rubber
plug and retain for future use.
12
A Name You Can Trust
Drain hole
Rubber plug
Drain Knob
FIG.22
FIG.23