Page 3
INTRODUCTION Sper Scientific warrants this product against defects in materials and workmanship for a period This IR Thermometer is a non-contact, infrared temperature of five (5) years from the date of purchase, and measurement instrument that can be used in: HVAC, vehi- agrees to repair or replace any defective Thermometer without charge.
Page 4
PANEL DESCRIPTION BATTERY REPLACEMENT Replace the battery when the Low Battery Indicator (17) is displayed. Open the battery cover, install a fresh 9V bat- tery and close the cover. NOTES & PRECAUTIONS Read the following information carefully before attempting to operate or service the IR Gun. Only qualified technicians should perform repairs.
Page 5
CLEANING LCD DESCRIPTION Clean the lens with compressed air, soft brush or a moist cotton swab. Do not use solvents on the lens. Clean the housing with mild soap on a cloth or sponge. SCAN HOLD °C SPECIFICATIONS AUTO DATA9 °F 193.5 D:S Ratio...
Page 6
DISTANCE-TO-SPOT ADVANCED FUNCTIONS High Alarm (HAL) The distance-to-spot ratio is 12:1. As the distance from the object increases, the spot size of the area measured also 1. Pull the Trigger (3), then press the Function (19) but- increases. ton until HAL (12) appears on the display. 2.
Page 7
ADVANCED FUNCTIONS MEASUREMENT PROCEDURES Maximum/Minimum (cont.) Measure Temperature (Scan) 4. The lowest recorded temperature is displayed. The dis- 1. Slide the Laser ON/OFF selector switch (5) to turn the play will change only if/when a lower temperature is re- Laser Guide (1) on or off. corded.
Page 8
ADVANCED FUNCTIONS ADVANCED FUNCTIONS To access the advanced functions, pull and hold the Data Record Trigger (3) and press the Function (19) button, then re- 1. Pull the Trigger (3), then press the Function (19) but- lease the Trigger. ton until DATA (15) followed by a number from 0 to 9 appears on the display.
Need help?
Do you have a question about the 800105 and is the answer not in the manual?
Questions and answers