Connecting To The System; General Requirements; Location - Estyma iGNEO COMPACT User Manual

2 Connecting to the system

2.1 General requirements

Read this operation manual carefully and thoroughly before you start using the unit.
The person installing the unit should have sufficient technical experience.
Copper wire connections should be designed to work in temperatures of up to +75ºC .
All connections made must be as shown in the electrical wiring assembly drawings and must be
compliant with national and/or local regulations concerning electrical connections.

WARNING !!! The device must be connected to a separate electrical circuit
equipped with an appropriately sized circuit breaker and residual current circuit breaker.

2.2 Location

The unit is intended for indoor installation only. After selecting the location, make sure
that it meets the following requirements:
1. The location must be free from excessive humidity and from flammable or corrosive
vapours.
2. The unit must not be installed near high power electrical equipment, electrical
machines or welding equipment.
3. The temperature in the location must not exceed 60ºC and should not be lower than
0ºC. Humidity should be within the range from 5% to 95%, with no vapour condensation
taking place.
estyma electronics
www.estyma.pl
2 Connecting to the system
page 9
PL20110629