Sonda Lambda - Estyma iGNEO COMPACT User Manual

7.1 Sonda Lambda

Lambda sensor we can connect to the system in two ways:
directly to the controller, if the entire system with CAN bus module will only use
–
Lambda oxygen sensor,
through enlargement module I/O with the number 5, if in the system there are
–
other modules enlargement.
After connecting the module configure the controller yet. For this purpose, proceed as
explained below.
From the main menu select SETTINGS
Then in the mode SERVICE enter the access code
After inputting the correct code, run the MODULES CONFIGURATION
estyma electronics
www.estyma.pl
7 Expansion of the system - CAN bus
page 51
PL20110629