Estyma iGNEO COMPACT User Manual page 52

7 Expansion of the system - CAN bus
Find Lambda Module and turn it on by changing the option to YES
At this point, turned on the module Lambda. The second step is a change the configuration
settings for the burner.
From the main menu by selecting BURNER we get to the settings
Here you can again enter the mode SERVICE and if required, enter the access code
In the list, you can locate the position Lambda control, which switches on YES.
It is also possible working with switched off Lambda control mode. Then Lambda oxygen
sensor module will be responsible only for displaying the measurements.
page 52
PL20110629