Estyma iGNEO COMPACT User Manual page 27

CH temp. for corr. factor
Mode type
Manual Tch
Room temp. sensor
CH temp. sensor
Permanent pump
estyma electronics
www.estyma.pl
Service
Central heating temperature correction
required the desired room temperature for 1 º
C. For example, if the correction factor is set
at 6 ° C, room temperature set at 20 ° C and
measured in the room is 20.5 ° C then the
temperature calculated at will be reduced by
3 ° C.
Specifies the input mode central heating
temperature:
manual - the temperature of central heating
inflicted manually,
weather - the temperature of central heating
calculated from the heating curve.
The desired temperature of central heating
when the mode is set to manual.
Specifies whether the system uses a room
sensor.
Specifies whether the system uses a sensor
heating.
Yes - the pump runs at a given temperature
in the room, reduced the temperature for
heating (only with the use of a sensor for
central heating and room sensor),
No - after reaching the set temperature in the
room the pump is turned off.
6 Main menu
page 27
PL20110629